![]() to target a gamma 2.2 “output offset” (pure power) curve, set tone curve to “Gamma 2.2”. If you want to target a different tone curve for the 3D LUT, go to the “3D LUT” tab and adjust the options as desired.Note that this setting does not influence the 3D LUT tone curve, which you can adjust in the next step. If you do want to use iterative gray balance calibration, set calibration tone curve on the “Calibration” tab from “As measured” to “Rec. The 3D LUT presets are set up to not use iterative gray balance calibration, as normally it shouldn’t be needed.If the display is well-behaved, the effect may be negligible. If you need to save time, you may reduce the amount of measured patches at the cost of accuracy. ![]() More patches increase measurement and profile processing time as well as characterization accuracy. The default 1553 patches should already give good results.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |